This is done from the Configure Terminal Mode.
**Creating a VLAN**
Specify the VLAN number (ID) and optionally give it a descriptive name:
```
Switch(config)# vlan 10
Switch(config-vlan)# name Engineering
Switch(config-vlan)# exit
```

**Setting a Port as an access port:**
```
Switch(config)# interface FastEthernet 0/1
Switch(config-if)# switchport mode access
Switch(config-if)# switchport access vlan 10
Switch(config-if)# exit
```

**Setting a Port as a trunk port:**
```
Switch(config)# interface GigabitEthernet 0/1
Switch(config-if)# switchport trunk encapsulation dot1q
Switch(config-if)# switchport mode trunk

//Only if you want to limit the allowd vlans.

Switch(config-if)# switchport trunk allowed vlan 10,20,30

```
